Index Beech 90 series

-

  Index Beech 90 Series

  1.  Index 
  2. 0 Type Rated Training 
  3. 01 Maintenance Data
  4. 02 Introduction of Aircraft
  5. ATA05 Time Limit & Maintenance Check
  6. ATA06 Dimensions & Area
  7. ATA07 Lifting Procedure
  8. ATA08 Leveling and Weighing 
  9. ATA09 Towing & Taxing 
  10. ATA10 Storage
  11. ATA11 Placard and Marking
  12. ATA12 Servicing 
  13. ATA20 Standard Practices - Airframe
  14. ATA21 Environmental/Air Conditioning

  15. ATA22 Auto Flight
  16. ATA23 Communications

  17. ATA24 Electrical Power

  18. ATA25A Electronic Emergency Equipment
  19. ATA25 EQUIPMENT/FURNISHINGS
  20. ATA26 Fire Protection
  21. ATA27 Flight Controls

  22. ATA28 Aircraft Fuel System

  23. ATA29 Hydraulic Power

  24. ATA30 Ice & Rain Protection
  25. ATA31 Indicating/Recording Systems

  26. ATA32 Landing Gear 
  27. ATA33 Lights

  28. ATA34 Navigation/Pitot-Static
  29. ATA35 Oxygen
  30. ATA36 Pneumatic
  31. ATA37 Vaccum System
  32. ATA38 Water/Waste
  33. ATA39 Electrical Panels, Parts & Instruments
  34. ATA44 Cabin System
  35. ATA46 Information System
  36. ATA51 STANDARD PRACTICES, GENERAL
  37. ATA52 Zone & Station Identification
  38. ATA 53 Fuselage
  39. ATA 54 NACELLES/PYLONS
  40. ATA 55 STABILIZERS
  41. ATA 56 WINDOWS
  42. ATA57 WINGS
  43. ATA60 Standard Practices - Propeller
  44. ATA61 Propeller General
  45. ATA70 STANDARD PRACTICES - ENGINES
  46. ATA71 Power plant

  47. ATA72 Engine Turbine/Turboprop

  48. ATA73 Engine Fuel and Control

  49. ATA74 Ignition System
  50. ATA75 Engine Air System

  51. ATA76 Engine Control
  52. ATA76 Enigne Control-Prop Governor
  53. ATA77 Engine Indicating System

  54. ATA78  Exhaust

  55. ATA79  Engine oil System Pr Oil

  56. ATA 80 Starting

Comments

Post a Comment

Popular posts from this blog

44 Cabin systems

-
TTP B1-L2 ATA 44 Beech 90 Series B2-L3 Cabin S ystems 44 CABIN SYSTEMS  -00 General  -10 Cabin Core System  -20 Inflight Entertainment System  -30 External Communication System  -40 Cabin Mass Memory System  -50 Cabin Monitoring System  -60 Miscellaneous Cabin System PTP  Beech 90 Series B1 LOC B2 LOC FOT SGH R/I MEL TS
Read more

Time Limit/Maintenance Check

-
  TTP B1-L1 ATA05 Beech 90 Series B2-L1 Time Limit/ Maintenance Check Inspection Requirements (1) 200-Hour Phase inspection program -  A complete inspection is 800 hours or 24 months, w hich e v er occurs first. The inspection c ycle is d i vided into four phases and each inspection c ycle is accomplished at 200 hours.  Section 5-10-01 . (2) Alternate Phase inspection program   F or operators f l ying less than 400 hours b ut more than 200 hours in 24 months.   P erfo r m scheduled phase inspections 1 and  2 t o gether within 12 months after the last  inspection.   P erfo r m scheduled phase inspections 3 and  4 t o gether within 12 months after complet - ing the phase 1 and 2 inspections.  Section 5-20-00. (3) Biennial inspection program   F or operators f l ying less than 200 hours in 24 months. ...
Read more

27 Flight Controls

-
  TTP B1-L3 ATA 27 Beech 90 Series B2-L2 Flight Controls INTRODUCTION   The aircraft uses co n v entional three-axis flight controls; ailerons, el ev ators, and a r udde r . T w o electr i cal l y dr i v en flaps are on each wing. Ground steering is accomplished b y the r udder pedals through a mechanical steering rod attached to the nose landing gea r . GENERAL   LJ-1 AND AFTER; L W-1 AND AFTER   Flight-control  m o v ement   is   accomplished through single non-redundant ca b les, push rods, and bell cranks, and are non-p o w ered (with the e xception of the r udder boost). The ailerons and el ev ators are controlled b y co n v entional control columns  interconnected   to  a T -column   behind the   inst r ument   panel.  The   r udder   is   operated with co n v entional r udd...
Read more