PLACARDS AND MARKINGS

-

 

TTP

B1-L1

ATA11

Beech 90 Series

B2-L1

Placard and marking

Placards and markings on the exterior surfaces of the airplane are found in the Beech 90 Series AMM, Chapter 11.
Interior and Exterior Placard and Decal Inspection
All required interior placards and limitation markings are listed in “Limitations” of the POH and the  FAA-approved Aircraft  Flight  Manual (AFM).

The model designation placard is on the external fuselage (left side), below the vertical stabilizer. The placard identifies the aircraft by its model and serial number (SN). 
  

Any time an aircraft is repainted or touched up, inspect all placards to ensure they are not covered with paint, are legible, and are securely attached. If the decals on the wing attach fittings are being replaced, sand the wing attach fittings lightly in the required area but do not remove the primer. Wash the area  with  an  approved  solvent  and apply the decal. Seal the edges with an approved edge sealer.



PTP 

Beech 90 Series

B1

LOC

 

 

 

 

B2

LOC

 

 

 

 

Inspection of the placards, decals, and markings.
(1) Examine the interior of the airplane. Include the aft baggage areas for the installation of all required placards, decals, and markings.
(a) For required placards, decals, and markings, refer AMM
(2) Examine the exterior of the airplane for the installation of all required placards, decals, and markings..
(3) Examine the airplane identification (ID) plate.
(a) The ID plate is found on the left side of the stinger, Zone 310.

Comments

Post a Comment

Popular posts from this blog

29A Hydraulic Power-Monitoring and Indication

-
  TTP B1-L3 ATA 29A Beech 90 Series B2-L3 Hydraulic Power – Monitoring and indicating Hydraulic Fluid Low-Level Sensor A h ydraulic fluid l o w-l e v el sensor is on the motor end of the p o w e r pack. A HYD FLUID LO annu n - ciator illuminates w hen a l o w fluid e xists . Engine b leed ai r , r e gulated to 18 to 20 psi, is plumbed into the fill rese r v oir to pr e v ent c a vit a tion of the pump.          A y ell o w HYD FLUID LO annunciator on the glare shield illuminates w hen the h ydraulic fluid in the seconda r y rese r v oir becomes l o w . An   optical   sensing   unit   on   the   motor end of the p o w e r pack contains the light source, senso r ,   and   s witching   circuit r y   to   trigger   the fluid   l o w   annunciato r .   The ...
Read more

56 Windows

-
Image
TTP B1-L3 ATA 56 Beech 90 Series B2-L1 Windows The King Air for w ard windshields are fo r med from t w o-p l y glass in an int e g ral aluminum frame. The t w o glass plies are bonded t o gether with a center po l yvi n yl sheet that co n tains the fine wire heating g rids. The windshields are electrostatical l y  coated and cu r rent-production windshields are sur f ace sealed. All the side wind o ws are const r ucted from ac r ylic plastic. WINDSHIELDS   The electrical l y heated laminated glass windshield is subject to the g radual process of delamination due to the effect of chemical action and differentials of temperature and pressure incu r red during pressurized flights at v a r ying altitudes and under v a r ying w eather conditions. This delamination is not detrimental to the st r uctural int e g rity of the windshiel d , b ut ...
Read more