27A Flight Control Surfaces

-

 

TTP

B1-L3

ATA 27A

Beech 90 Series

B2-L1

Flight Control Surfaces






PTP 

Beech 90 Series

B1

LOC


TS

B2



Comments

Post a Comment

Popular posts from this blog

44 Cabin systems

-
TTP B1-L2 ATA 44 Beech 90 Series B2-L3 Cabin S ystems 44 CABIN SYSTEMS  -00 General  -10 Cabin Core System  -20 Inflight Entertainment System  -30 External Communication System  -40 Cabin Mass Memory System  -50 Cabin Monitoring System  -60 Miscellaneous Cabin System PTP  Beech 90 Series B1 LOC B2 LOC FOT SGH R/I MEL TS
Read more

Time Limit/Maintenance Check

-
  TTP B1-L1 ATA05 Beech 90 Series B2-L1 Time Limit/ Maintenance Check Inspection Requirements (1) 200-Hour Phase inspection program -  A complete inspection is 800 hours or 24 months, w hich e v er occurs first. The inspection c ycle is d i vided into four phases and each inspection c ycle is accomplished at 200 hours.  Section 5-10-01 . (2) Alternate Phase inspection program   F or operators f l ying less than 400 hours b ut more than 200 hours in 24 months.   P erfo r m scheduled phase inspections 1 and  2 t o gether within 12 months after the last  inspection.   P erfo r m scheduled phase inspections 3 and  4 t o gether within 12 months after complet - ing the phase 1 and 2 inspections.  Section 5-20-00. (3) Biennial inspection program   F or operators f l ying less than 200 hours in 24 months. ...
Read more

27 Flight Controls

-
  TTP B1-L3 ATA 27 Beech 90 Series B2-L2 Flight Controls INTRODUCTION   The aircraft uses co n v entional three-axis flight controls; ailerons, el ev ators, and a r udde r . T w o electr i cal l y dr i v en flaps are on each wing. Ground steering is accomplished b y the r udder pedals through a mechanical steering rod attached to the nose landing gea r . GENERAL   LJ-1 AND AFTER; L W-1 AND AFTER   Flight-control  m o v ement   is   accomplished through single non-redundant ca b les, push rods, and bell cranks, and are non-p o w ered (with the e xception of the r udder boost). The ailerons and el ev ators are controlled b y co n v entional control columns  interconnected   to  a T -column   behind the   inst r ument   panel.  The   r udder   is   operated with co n v entional r udd...
Read more